Valves In Stock

News

AWWA C515 SPec, A/C, Steel, PVC, Ductile Iron, or Cast Iron Pipe. Resilient Seat Gate with 250 psi working pressure

Insert Valve Install Services 6” through 8”

(ANSI 250 psi or less)

International Flow Technologies (IFT) performs valve inserting on pipelines without shutting down the system. Valves can be installed indoors and outdoors on chilled and domestic water and air lines Our customers include hospitals, industrial companies, mechanical contractors, and municipalities. By using the InsertValve IFT installs a real AWWA spec C515 valve on your system designed for continuous use. IFT is certified to train for the certification of Valve Inserting equipment packages.
Call 1-800-221-3332

Below are pictures of some of IFT's past insert valve installsalations. We have successfully installed over 100 insert valves throughout the USA. IFT prides itself on the success of this valve and will continue to provide the United States with our services.

Unique Features

Meets or exceeds ANSI/AWWA C515 valve specification
Meets or exceeds ANSI/AWWA C 550 Standards and ANSI/NSF 61
AWWA standard turns per inch to open
Gate wedge seats on valve body, not on pipe bottom
Gate wedge does not come in contact with sharp cut edge of pipe
Ductile Iron body with nominal 10 mil power coat epoxy inside and out
250psig (1273 kPa) Maximum working pressure
Shell tested to 1000 psi, Gate tested to 500 psi
Ductile Iron wedge totally encapsulated with EPDM molder rubber
Triple O'ring seal stuffing box (two upper & one lower)
2" standard operating nut (Handwheel optional) NRS ( non-rising stem)
Standard valve body installs on full range of pipe sizes and types (Steel, PVC, C900, CL, DI, AC)
Made in the USA from start to finish
Valve body permanently restrains the valve to the pipe
The valve body can accept the Butterfly Cartridge in lieu of the gate assembly
Hundreds of successful installs without a single malfunction (references available)
The valve size is 4"-12" and other sizes available upon request